Sapphire Plug-ins for Open Fx: Dissolve

S_Dissolve A basic cross fade between two input clips. In the Sapphire Transitions effects submenu. Inputs: From: Optional. Starts the transition with this clip. To: Optional. Ends the transition with this clip.

Parameters:

Load Preset: Push-button .
Brings up the Preset Browser to browse all available presets for this effect.

Save Preset: Push-button .
Brings up the Preset Save dialog to save a preset for this effect.

Dissolve Amount: Default: 0, Range: -0.5 to 1.5.
The transition ratio between the From and To inputs. A value of 0 gives only the From input and a value of 1 gives only the To input. By default this parameter automatically animates from 0 to 1 to perform a complete transition.

Dissolve Speed: Default: 1, Range: 1 or greater.
The speed of the dissolve between the From and To clips. When set to 1, the dissolve takes place over the entire duration of the effect. When set higher, the dissolve is shorter, although the glow ramp-up and ramp-down still takes the entire duration. Setting this to 10 can make the transition snappier and more like a flash-frame cut.

Slow In: Default: 0.2, Range: 0 to 1.
If positive, causes the transition to start more gradually.

Slow Out: Default: 0.2, Range: 0 to 1.
If positive, causes the transition to end more gradually.

See Also:

DissolveBlur DissolveBubble DissolveDiffuse DissolveFilm DissolveGlow DissolveLuma DissolvePuddle DissolveSpeckle DissolveStatic DissolveVortex DissolveWaves

Sapphire Plug-ins Introduction